Education

june 2003 Vocational at COBSAT

Experience

November 2016 INstrument Foreman at BBSA Babcock Borsig Services Arabia

1. Installation of proximitor series 3500 Bentley Nevada and sensors for eccentricity, key phasor, speed pick up, zero pick up, HP/LP differential expansion. Adjust gap voltage in accordance with the turbine protection and specification.
2. Installation of vibration sensors in GRF gas recirculation fan, FDF force drop fan, BFPT boiler feed pump turbine, CWP cooling water pump, BCP boiler circulation pump, Compressor, seismic sensors and proximitor series 7200 Bentley Nevada for bearing and casing and adjust gap voltage.
3. Installation of proximity switch for rotating equipment and loop testing of instrument, installation of thermocouple for the turbine bearing temperature. Knowledge of installation of Bentley Nevada card series 3500 and 7200.
4. Adjust LVDT for MSV main stop valve, GOV governor valve, RSV reheat stop valve, ICV interrupted control valve. Installation of servo valve for the Governor.
5. Cable pulling, glanding and termination of instrument cable from field device to panel
6. Calibration 0f instrument like level, flow, pressure, temperature transmitter, level switch, temperature switch, pressure switch, calibration of control valve, such as masoneilan, Siemens, abb, fisher azvil positioner. Testing and commissioning of burner gun, burner tilt.

May 2014 to June 28 2015 Instrument Foreman at PE Dongyeong Contracting Company

1. Making written and verbal report in the area of assignment.
2. Understand schematic diagram and cable termination from DCS to field devices.
3. Read location drawing, P&ID and Hoop Up drawing
4. Supervise and ensure installation in compliance with client’s standards, various types of rotating equipment monitoring and control system, like vibration, temperature, displacement and speed (Bentley Nevada).

February 07, 2013 –toAugust 18, 2014 Instrument Technician at BEMCO

Making daily report and progresses in the area of assignment using Microsoft windows application.
2. Handle simulation and loop testing.
3. Adjust valve positioner and analog output of MOV, AOV, I/P valve, hydraulic valve.
4. Able to read MSD master schematic diagram and cable termination to the field device.
5. Glanding and cable termination to the DCS panel from field devices.
6. Knowledge in commissioning of field device using HART communicator and simulator.
7. Simulation and loop check of field device such as flow, level, pressure, temperature transmitter using fluke simulator and HART communicator.
8. Loop checking and pre-commissioning of sensors such as bearing temperature, winding temperature, level switches, pressure switches, limit switches, vibration sensors, reverse sensor, flow switch, protection trip of the motors to CMS Continues Monitoring System Panel.

Aug 7, 2008 – Feb. 08, 2011 Building Maintenance Electrician at Remal AL Sawahel

1. Perform scheduling for lightings and equipment such as motor pumps, exhaust fan, AHU and FCU.
2. Perform skilled electrical works and provide work direction to lower classified electrician as required.
3. Prepare electrical materials, lay-out control panels for lights, outlets and motors.

Coordinate with foremen and receive work assignment and checking on work progress.
4. Perform preventive maintenance of electrical equipment and instrument control.
5. Make verbal and written reports to supervision regarding conditions and problems encountered in the area of assignment.
6. Install, maintain and repair system, sets wiring system, sets power and lighting boards and panel, connect motors and control and install fixtures.
7. Maintain the operation of the emergency generator.
8. Practice good housekeeping including jobsite cleanup and conforms to safety
standards, rules and practices