Ria Luna V. Celada Chemical Engineer

UAE Linkedin
Chemical AnalysisChemical Process EngineeringDocument ControlMaterials EngineeringPollution Control nad ManagementQuality Assurance and ManagementStatistical Process Control


Address: Sunrise Bldg., Al Barsha 1, Dubai

Mobile #: +971 563824588

Email address: [email protected]


A licensed chemical engineer with extensive knowledge and experience in chemical analysis, process control, quality assurance, quality control, quality system management, manufacturing and laboratory operations, and failure analysis.
Possessing drive and positive attitude required to be successful in an engineering field.


Passed the licensure examination for Chemical Engineers conducted by Professional Regulation Commission given in April 2013.


Degree: Bachelor of Science in Chemical Engineering Cebu Institute of Technology – University, Philippines, October 2012

Diploma: Material Science and Engineering Technology Mindanao State University – Iligan Institute of Technology, Philippines, April 2006


Cypress Manufacturing Ltd., General Trias, Cavite, Philippines

Failure Analysis Engineer June 2015 – May 2016

Solves analytical cases that require material analysis by doing non destructive and destructive tests on defects found in integrated circuits. Manages the entire laboratory operation of the failure analysis department in compliance to safety procedures. Performs design of experiments related to cost reduction and initiates projects that have impact in statistical process control.

Materials Associate Specialist March 2009 – April 2010

Responsible for material management and inventory tracking. Involves in repair, store, inventory, technical, maintenance planning, and production interfaces.

Quality Control Inspector June 2007 – March 2009

Conducts thorough and sampling inspection in assembly, test, back-end, and finished good areas for any non-compliance to quality policy and procedures. Responsible for safe and efficient operation of product testing for functional reliability and provide valid test results on all manufactured integrated circuits. o Supports the statistical process control team’s projects related to process improvement.

Hammon Plating technology Inc., Dasmarinas, Cavite, Philippines

Quality/ Process Supervisor April 2014 – May 2015

Supervises the production team in providing quality products to customers in timely manner with zero defect. Establishes and implements process control plans to ensure high quality standard in compliance to AS9100C and ISO 9001 requirements. Leads in conducting 8D analysis to solving quality problems. Analyzes plating bath concentration and performs corrective actions for the out of control results. Responsible for pollution control and management.

Philippine Associated Smelting and Refining Corporation, Isabel, Leyte, Philippines

Metallurgical Laboratory Tech. October 2005 – March 2006

Performs experiment on neutralization of discharged effluents from refinery plant. o Treats sludge for high recovery of precious metals. Conducts inspection on copper cathodes to check for surface defects.


ISO 9000 and ISO 14000 Cypress Manufacturing Ltd., Philippines, July 2015
Statistical Process Control Cypress Manufacturing Ltd., Philippines, July 2015
Introduction to Machinability & Machining of Stainless Steels and Super Alloys SECO Technical Education Programme, Philippines, June 2014


Age: 30

Nationality: Filipino

Status: Single

Languages: English, Filipino


October 2012 Bachelor of Science in Chemical Engineering at Cebu Institute of Technology - University
April 2006 Diploma in Material Science and Engineering at Mindanao State University - Iligan Institute of Technology